Teledyne LeCroy WaveSurfer MXs-B Getting Started Manual - Manual (Page 112)

WaveSurfer MXs-B Oscilloscopes
104 922172-00 Rev A
EN 61010-1:2010 Safety requirements for electrical equipment for
measurement, control, and laboratory use – Part 1: General requirements
EN 61010-2:030:2010 Safety requirements for electrical equipment for
measurement, control, and laboratory use – Part 2-030: Particular
requirements for testing and measuring circuits
The design of the instrument has been verified to conform to the following
limits put forth by these standards:

Overvoltage Category II: this refers to equipment intended to be
supplied from the building wiring with a nominal supply voltage up
to 300V.

Measurement Category O: this refers to oscilloscope measurement
terminals that are not intended to be directly connected to the
MAINS supply.

Pollution Degree 2: this refers to an operating environment where
normally only dry, non-conductive pollution occurs. Occasionally a
temporary conductivity that is caused by condensation must be
expected. This location is a typical office/home environment.

Protection Class I: this refers to grounded equipment, in which
protection against electric shock is achieved by Basic Insulation and
a connection to the protective ground conductor in the building
wiring.
U.S. N ATIONALLY R ECOGNIZED A GENCY C ERTIFICATION
The oscilloscope has been certified by Underwriters Laboratories (UL) to
conform to the following safety standard and bears UL Listing Mark:
UL 61010-1 Third Edition – Safety standard for electrical measuring and test
equipment.
C
ANADIAN
C
ERTIFICATION
The oscilloscope has been certified by Underwriters Laboratories (UL) to
conform to the following safety standard and bears cUL Listing Mark:
CAN/CSA-C22.2 No. 61010-1-12. Safety requirements for electrical
equipment for measurement, control and laboratory use.