Teledyne LeCroy WaveSurfer MXs-B Getting Started Manual - Manual (Page 27)

Getting Started Manual
922172-00 Rev A 19
Mouse and Keyboard Operation
In the procedures, we focus on using the front panel for common
operations, and the touch screen for making selections. But, if you have a
mouse connected to the instrument, you can click on objects instead of
touching them. Likewise, if you have a keyboard connected, you can use it
to enter data instead of using the virtual keyboard provided by the
instrument.
Turning on Channels and Traces
Connect a signal to a channel (we’ll assume you connected to channel 1 in
this example and that the channel was not already ON).
Press the channel 1 button on the front panel to turn on channel 1. The
button lights and the descriptor label for that channel are shown.
If the signal is not on the grid, press the AUTO trigger button and adjust
Horizontal and Vertical front panel controls to adjust the settings and
display the signal, or simply press the AUTOSETUP button to quickly bring
most repetitive signals onto the grid.
If you need to change probe attenuation, coupling,
or bandwidth limiting, open the channel setup dialog
for channel 1 by touching the descriptor label for
channel 1. Press this button twice if it is not the
active trace.
Or, use the Vertical  Channel 1 Setup selection
from the menu bar to open the channel 1 setup
dialog.