Teledyne LeCroy WaveSurfer MXs-B Getting Started Manual - Manual (Page 18)

WaveSurfer MXs-B Oscilloscopes
10 922172-00 Rev A
AutoSetup Button
Automatically sets timebase, trigger, and sensitivity to
display a wide range of repetitive signals.
Measure, Zoom, and Math Quick Buttons
Measure – Press once to open the measure dialog.
Press again to close the dialog.
QuickZoom – Press once to create zooms of all
displayed channels. Press again to unzoom.
Math – Press once to turn on the Math trace, and
display the Math Setup dialog. Press again to close the
dialog.
Cursor Knobs and Buttons
The WaveSurfer MXs-B oscilloscope has dedicated dual
cursor knobs for cursor control. Cursors always default
to a relative state (two cursors ON).
Knobs – Rotate to adjust cursor position. If Cursors are
OFF, rotating either knob turns Cursors ON. At this
point, push in the button to set it as the default
position.
Type Button – Pressing the Type button once turns
Cursors ON to Horizontal (Time) measurements.
Pressing the button again changes it to Vertical
(Amplitude) measurements. Pressing it a third time
turns the Cursors OFF.