Teledyne LeCroy WaveSurfer MXs-B Getting Started Manual - Manual (Page 25)

Getting Started Manual
922172-00 Rev A 17
Descriptor Labels
Information is contained in rectangular boxes called descriptor labels.
These labels contain status information, and also act as shortcuts to the full
dialog when you touch them. Channel descriptor labels are displayed only
for channels that are turned on. Timebase and trigger descriptor labels are
always displayed.
Channel trace labels show the vertical settings for
the signal. The title bar (colored area) of the label
shows the channel number on the far left.
Other information is indicated on the title bar, as
follows:

Coupling (AC 1M

, DC 1M

, DC 50

, GND)

Deskew (DSQ) set to non-zero value

Bandwidth Limiting (BWL) ON

Averaging (AVG) ON

Interpolation

Inversion

Probe attenuation

Enhanced Resolution (ERES) ON
Some of these indicators may be abbreviated if
several are on at one time.
Touch a channel descriptor label once to make the
front panel vertical controls active for that channel.
Touch it again to open the software dialog for
further adjustment.
If cursors are ON, cursor information for this channel
appears on this trace label.
The title bar of the TimeBase (Horizontal) label
shows the trigger delay setting at the far right. Time
per division, sample rate, and number of samples
are indicated below the title bar.