Teledyne LeCroy WaveSurfer MXs-B Getting Started Manual - Manual (Page 37)

Getting Started Manual
922172-00 Rev A 29

Level – the threshold at which the trigger will occur, specified in
volts.

Slope – the direction of the trigger voltage transition used for
generating a particular trigger.
Trigger Setup
Trigger Delay
The trigger delay Indicator is a color-coded
triangle that is positioned horizontally on the grid.
Trigger delay horizontally positions the
oscilloscope trace on the display so you can
observe the signal prior to the trigger time. Delay
adjusts the pre- and post-trigger time. Pre-trigger
delay is adjustable from 0-100%
Post-trigger delay is indicated by a color-coded
arrow pointing to the left. Post-trigger delay is
adjustable from 0-10,000 divisions (calculated in
time)
All trigger delay values (including post-trigger
delay, shown here) are displayed in the Timebase
Descriptor Label.
Zero delay is the horizontal center of the oscilloscope display.
Change trigger delay by using the D
ELAY
front panel knob in the
HORIZONTAL control area. Rotate the knob to adjust, or push to zero.