Teledyne LeCroy WaveSurfer MXs-B Getting Started Manual - Manual (Page 69)

Getting Started Manual
922172-00 Rev A 61
Working with Sampling Modes
Sequence Mode Setup
When setting up Sequence Mode, you define the number of fixed-size
segments acquired in single-shot mode (see the instrument specifications
for the limits).
The oscilloscope uses the sequence timebase setting to determine the
capture duration of each segment. Along with this setting, the oscilloscope
uses the number of segments, maximum segment length, and total
available memory to determine the actual number of samples or segments,
and time or points.
1. Touch Timebase → Horizontal Setup on the menu bar.
2. Click the Sequence tab.
3. Under Acquisition Settings, touch inside the Number of Settings
data entry field and enter the number of segments you want to
display.
NOTE: The number of segments you choose to display can be less
than the total number of segments in the waveform. For example, in
the pop-up images above, the number of display segments is 10, but
the total number of segments entered in the timebase dialog's
Number of Segments field is 100.