Teledyne LeCroy WaveSurfer MXs-B Getting Started Manual - Manual (Page 30)

WaveSurfer MXs-B Oscilloscopes
22 922172-00 Rev A
Opens a Measurement selection pop-up menu. You can then
select up to 6 parameters (measurements) for the active
channel from this menu without leaving the Channel Setup
dialog. The parameter automatically appears below the grid.
Creates a zoom trace of the channel signal. The zoom trace
becomes active, and you can use the Vertical and Horizontal
controls to modify its scale and position.
Opens a Math selection pop-up menu. You can then select a
math function for the active channel from this menu without
leaving the Channel Setup dialog. The Math trace is then
displayed in its own grid.
Copies the channel trace into its corresponding Memory
(Reference Waveform) location. For instance, C1 is loaded
into M1, C2 is loaded into M2, etc.
Automatically performs a vertical scaling that fits the
waveform into the grid.
Opens a Labeling pop-up menu that allows user-defined
labels tied to the waveform.
TimeBase
Timebase Setup and Control
Set up the Timebase by using the front panel Horizontal controls or the
Timebase menu bar, trace descriptor label and dialog box.
1. Touch Timebase → Horizontal Setup on the menu bar. The
Timebase dialog is shown.
2. Touch inside the Time/Division data entry field and enter a value.
3. Touch inside the Delay data entry field and enter a value.