Show metrics in the bus utilization window – Teledyne LeCroy PETracer EML Analyzer and Exerciser User Manual User Manual
Page 176
Chapter 9: Reports and Tools
PETracer EML User Manual
168
LeCroy Corporation
Show Metrics in the Bus Utilization Window
The Bus Utilization window provides graphs for packet-level information in the
CATC Trace. The window also provides graphs for information on Split and Link
Transaction levels, plotted over time. The graphs for Split and Link Transaction levels are
based on metrics collected for the transactions throughout the CATC Trace.
The seven graphs related to Split and Transaction levels are:
1. Pending Requests at Split Transaction level.
2. Response Time at Split Transaction level.
3. Latency Time at Split Transaction level.
4. Throughput Per Transaction at Split Transaction level.
5. Response Time and Latency Time at Split Transaction level (combined graph).
6. Response Time at Link Transaction level, for Memory Writes only.
7. Throughput at Link Transaction level, for Memory Writes only.
The following is an example of Bus Utilization window display of graph numbers 1, 4, 5,
6 and 7: