Teledyne LeCroy PETracer EML Analyzer and Exerciser User Manual - Manual (Page 45)

PETracer EML User Manual Chapter 3: Installation
LeCroy Corporation
37
Step 5 Attach probe data cables between the two connectors on the emulator
and the Transmit and Receive ports on the Exerciser.
Step 6 At this point the emulator is ready for use. Skip ahead to Section , “Final
Steps: Power On the Exerciser and DUT” on page 39.
Host Emulation Test Fixture - Description
Figure 3.3 Host Emulation Test Fixture with a PCI-E Graphics Card on Top
Figure 3.4 Host Emulation Test Fixture
LeCroy Host Emulation Test Fixture: Hardware enclosure with a slot on top for
accommodating a PCI Express card.
Data Cable Connector (To Exerciser Transmit): Connects to the Transmit port on
PETrainer EML.
Data Cable Connector (To Exerciser Receive): Connects to the Receive port on
PETrainer EML.
Bus Reset button: Reset asserts PERST # for > 250 ms
Signal Level switch:
• Hi = PCI Express compliant (0.9V - 1.2V)
• Low = Testing (0.45V - 0.65V)