Teledyne LeCroy PETracer EML Analyzer and Exerciser User Manual - Manual (Page 35)

PETracer EML User Manual Chapter 3: Installation
LeCroy Corporation
27
Chapter 3: Installation
PETracer EML™ is a factory-installed hardware module that is sold as part of the
Universal Protocol Analyzer System 100K (UPAS 100K).
PETrainer EML™ consists of two factory-installed hardware modules that are sold as part
of the Universal Protocol Analyzer System 100K (UPAS 100K).
The UPAS 10K, UPAS 100K, modules, and associated software are easily installed. You
can begin making PCI Express™ recordings or begin traffic generation after following the
steps in this chapter.
3.1 Installing the PETracer Software
PETracer software operates all of LeCroy’s PCI Express protocol Analyzer and Exerciser
products:
The PETracer software is installed on a Microsoft ® Windows ® -based PC and serves as
the interface for the Exerciser and/or Analyzer. When an Exerciser is attached, traffic
generation features are enabled.
To install the PETracer software on the Host PC:
Step 1 Insert the CD into the CD ROM drive of the PC that controls the Analyzer
or Exerciser. The installation window opens and displays links to the
PETracer software, user manuals, a readme file, and Acrobat Reader.
Step 2 Select Install Software and follow the onscreen instructions.
The PETracer software installs automatically on the PC hard disk. During
installation, all necessary USB drivers are loaded automatically. Drivers included
in the installation are:
• upas100k.sys: UPAS 100K driver, PETracer EML and PETrainer EML
driver
Step 3 To start the application, launch the PETracer program from the Start
menu: 
Start > Programs > LeCroy > PETracer > LeCroy PETracer