Teledyne LeCroy PETracer EML Analyzer and Exerciser User Manual - Manual (Page 216)

Chapter 10: Traffic Generation PETracer EML User Manual
208
LeCroy Corporation
10.6 Generating Traffic: Set Generation Options
Before beginning generation, set options in the Generation Options dialog box:
Step 1 Open the Generation Options dialog box by selecting
Setup > Generation Options from the menu. The Generation Options
dialog opens.
By default the General page displays.
Step 2 To test 1.0 devices, check the box next to
Base Spec Rev. 1.0 Compatibility Mode to select 1.0 compatibility
mode.
To test 1.0A devices, leave this box unchecked.
Step 3 Set the generation direction based on type of device you are emulating.
Step 4 Select one of the two Interposer options:
• Host Emulation: Select Host
• Device Emulation: Select Device
Step 5 Select the Link tab. The Link page opens.
Step 6 Select Enable Automatic Skip Generation, but leave the setting at the
default value: 4720 ns.
Step 7 Select the Integrity tab. The Integrity page opens.
Step 8 Check to enable Automatic ACK/NAK DLLP generation for received
TLP packets.
Step 9 Enable all four TLP policies and set ACK/NAK Delay = 0 ns.
Step 10 Select the Flow Control tab. The Flow Control page opens.
Step 11 Check the checkbox to enable Do not send TLP packet if credit
amount is insufficient.
Step 12 Check the checkbox to enable
Periodically schedule UpdateFC DLLP.
Step 13 Use the defaults for all other boxes.
Step 14 Click OK to apply all changes and close the Generation Options dialog.