Teledyne LeCroy Summit Z3-16 PCI Express Multi-lane Exerciser User Manual - Manual (Page 102)

Teledyne LeCroy NVME Drive Emulation in Windows 7
102 Summit Z3‐16 PCI Express Multi‐Lane Exerciser User Manual
6. Load the Drive Script from C:\Users\Public\Documents\LeCroy\PETracer\Sample
Files\Z3‐ 16TrainerScripts\NVMe_DriveEmulation\ start_nvme_drive.peg
7. Run the C:\Users\Public\Documents\LeCroy\PETracer\Sample Files\Z3‐
16TrainerScripts\NVMe_DriveEmulation\ start_nvme_drive.peg script to start
NVMe emulation.
8. Press the Connect button in the Generation bar.
9. Start recording.
10. Boot the PCIe system.
11. When New Device notifications appear, point the driver installation to the location
where you copied files in step 1, using "Have Disk". Go through the wizard to
complete the installation.
12. Make sure the LeCroy drive has appeared in the Device Manager. (See figure below,
but "NVMe NVMeLecroy000000 SCSI Drive" in "Disk drives" and also "Community
NVMe Storport miniport" under "Storage Controllers")