Teledyne LeCroy Summit Z3-16 PCI Express Multi-lane Exerciser User Manual - Manual (Page 95)

Summit Z3‐16 PCI Express Multi‐Lane Exerciser User Manual 95
Chapter 8
Updates and Licensing
8.1 Updating the Exerciser
BusEngine™ and/or Firmware updates are now automatic processes that run anytime a
new version of the PETracer™ software is installed that is incompatible with the currently
installed BusEngine or Firmware. The update process generates on‐screen instructions.
If, however, you need to manually perform BusEngine or Firmware updates, follow these
steps:
1. Select Setup > Update Device … from the menu to display the Update Analyzer
dialog for Summit Z3‐16™.
2. Select the appropriate file locations for the Firmware and/or BusEngine, using
Browse, if necessary.
3. Check the appropriate options (if in doubt, check all options).
4. Click Update Selected or Update All to initiate the updating of the Exerciser.
8.2 License Keys
A License Key is necessary to enable software maintenance. If you attempt to generate
traffic with the Exerciser without an installed License Key, a message appears to indicate
that a License Key is necessary in order to record traffic.
A License Key must be obtained from Teledyne LeCroy for each Exerciser.
After you obtain the License Key, follow these steps to install it:
1. Select Help > Display License Information… from the menu bar to display the Update
License dialog.
2. Click the Install License File... button to dis play the Select License Key File dialog and
enter the path and filename for the License Key to navigate to the directory that
contains the License Key.
3. Select the .lic file, and then click Open.
You can also update your licensing information by selecting Setup > All Connected Devices
…, then clicking Update License.