Teledyne LeCroy Summit Z3-16 PCI Express Multi-lane Exerciser User Manual - Manual (Page 28)

Teledyne LeCroy Adding Devices Manually
28 Summit Z3‐16 PCI Express Multi‐Lane Exerciser User Manual
Figure 3.8: Analyzer Devices Dialog Showing All Connected Devices
Note: To disconnect from a device, display this dialog, select the device, and click the
Disconnect button.
Note: Do not change from USB to Ethernet, or back, without power cycling the Exerciser.
3.4 Adding Devices Manually
You can locate and add a Summit Z3 located in a Ethernet subnet using the Add Device
button. Perform the following steps:
Click Setup ‐> All Connected Devices ‐> Add Device ‐> to display the Add Ethernet
Attached Device dialog.
Figure 3.9: Add Ethernet Attached Devices Dialog