2 connect macro, 3 disconnect macro, 4 adding new script macros – Teledyne LeCroy Summit Z3-16 PCI Express Multi-lane Exerciser User Manual User Manual
Page 76: Using the generation macros dialog
Advertising
Teledyne LeCroy
Macros
76
Summit Z3‐16 PCI Express Multi‐Lane Exerciser User Manual
5.1.2
Connect Macro
The default code for this macro is the following:
Config = General {TrainerReset = 1}
Link = Detect
Wait = 500
Link = L0
Wait = 500
Link = InitFC
5.1.3
Disconnect Macro
The default code for this macro is the following:
Config = General {TrainerReset = 1}
Link = Detect
5.1.4
Adding New Script Macros
There are two ways to add script macros:
Using the Generation Macros dialog
Adding script files to the GenScriptMacros directory.
Using the Generation Macros Dialog
1. Open the Generation Macros dialog by selecting Setup > Generation Macros from
the menu.
2. In the Generation Macros dialog box, click the New button.
Advertising