Extron Electronics SSP 7.1 User Guide - Manual (Page 31)

3. Click the Connect button (or Cancel to exit the program).
If you select Emulate, click on the Work Offline button (or Cancel to exit the
program).
Figure 15. Connect to device? Dialog Box — Emulate Mode
NOTE: When Emulate/Work Offline is selected, the Connect button is
replaced by a Work Offline button. Instead of establishing a connection
with the sound processor, the program allows you to create a configuration
that can be saved as a file and used to update the configuration of the
sound processor when the program is in Live mode.
When the program opens, you may still toggle between Live or Emulate modes by using
the buttons in the top right corner of the program window, as described in
“Live and
Emulate Modes” on page 23.
If you check the “Stop prompting me to connect upon startup” box, the next time the
program opens, this dialog box is not shown and the program automatically opens in
Emulate mode. Click the Live button in the program window to switch to Live mode.
To re-enable this box, use the menu system to navigate to Options>Re-enable Dialogs
(see
Re-enable Dialogs on page 53). This clears the check box in all dialog boxes and
all previously disabled pop-up messages occur regularly again.
SSP 7.1 • Setup and Control Software 25