Extron Electronics SSP 7.1 User Guide User Manual
Page 63
9.
Open the SSP 7.1 Setup and Control software and click on the Update Firmware
option in the Device menu. The Firmware Loader Add Device... dialog box opens.
Figure 42.
Add Device... Dialog Box
10.
Select SSP 7.1 from the device list, RS-232 as the connection method, select the
correct com port and baud rate (default rate is 38400) and click the Connect button.
The PC connects to the SSP 7.1.
When the connection is made, the name of the device appears, with a green check
mark, in the Connected Device box.
11.
Click the Browse button and navigate to the folder where the firmware file was saved
(see step 8).
12.
Click the Add button. The Add Device... box closes to reveal the main Firmware Loader
window.
Figure 43.
Firmware Loader Main Window
13.
Click on the Begin button.
14.
When the transfer is complete, the Total Progress box reads 100% and the entry in the
Status column reads Complete.
SSP 7.1 • Setup and Control Software
57