Extron Electronics SSP 7.1 User Guide - Manual (Page 93)

Command ASCII Command
(host to unit) Response
(unit to host) Additional Description
Subwoofer Output
Set subwoofer off
E J0SSP } SspJ X#] Sets subwoofer to Off.
X# — Status
0 = Off
1 = On (default)
Set subwoofer on E J1SSP } SspJ X#] Sets subwoofer to On.
View subwoofer control E JSSP } SspJ X#] Shows subwoofer status.
Output Channel Trim Settings
Set a specific output
channel trim
E V X@ * X3# SSP } SspV X@ * X3#] Set gain for the selected output:
X@ — Audio Outputs (1-8)
1 = Left front
2 = Center
3 = Right front
4 = Left surround
5 = Right surround
6 = Left back
7 = Right back
8 = Subwoofer
X3# — Output gain and attenuation
readout in dB (-24 to +12; default = 0)
View a specific output
channel trim E V X@ SSP } SspV X@ * X3#] View the current gain setting for the
selected output.
Speaker Delay Settings
Set delay to a specific
speaker
E D X@ * X1% SSP } SspD X@ * X1%] Set speaker delay for the selected
output:
X1% — Speaker delay (in 0.1 ms units;
default = 0 on all channels):
View delay to a specific
speaker E D X@ SSP } SspD X@ * X1%] View the current speaker delay for a
selected output
Farthest Speaker Distance
Set distance to the
farthest speaker
E K X& SSP } SspK X&]
NOTE: This command is included
for reference: it is for use
with the SSP 7.1 Setup and
Control Software only.
View distance to the
farthest speaker E KSSP } SspK X&]
Lip Sync Offset
Set lip sync offset per
input E Y X! * X2* SSP } SspY X! * X2*] Sets the lip sync offset ( X2* ) for the
specified input ( X! )
X2* — Lip Sync Offset 000 - 1000 in
0.1 ms increments (0 - 100 ms)
X! — Audio Inputs (1-5)
1 and 2 = Digital audio, optical input
3 and 4 = Digital audio, coaxial input
5 = Analog input
View lip sync offset per
input E Y X! SSP } SspY X! * X2*]
SSP 7.1 • SIS Commands 87