Extron Electronics SSP 7.1 User Guide - Manual (Page 98)

Command ASCII Command
(host to unit) Response
(unit to host) Additional Description
Parametric EQ Filter Frequency Setting for each Output Channel
Set frequency for each
filter and output channel
E F X@ * X4$ * X4%
SSE }
SseF X@ * X4$ * X4%] Sets the frequency for each filter and
output channel.
View frequency for each
filter and output channel E F X@ * X4$ SSE } SseF X@ * X4$ * X4%] Shows the current frequency for each
frequency and output channel.
Parametric EQ Filter Gain Setting for each Output Channel
Set gain for each filter
and output channel
E G X@ * X4$ * X4^
SSE }
SseG X@ * X4$ * X4^] Sets the gain for each filter and output
channel.
View gain for each filter
and output channel E G X@ * X4$ SSE } SseG X@ * X4$ * X4^] Shows the current gain for each filter
and output channel.
Parametric EQ Filter Q Setting for each Output Channel
Set Q value for each filter
and output channel
E Q X@ * X4$ * X4&
SSE }
SseQ X@ * X4$ * X4&] Sets the Q value for each filter and
output channel.
View Q value for each
filter and output channel E Q X@ * X4$ SSE } SseQ X@ * X4$ * X4&] Shows the current Q value for each filter
and output channel.
NOTE: X@
— Audio Outputs (1-8): 1 = Left Front, 2 = Center, 3 = Right Front, 4 = Left Surround Side, 5 = Right Surround Side,
6 = Left Surround Back, 7 = Right Surround Back, 8 = Subwoofer
X4$
— Parametric EQ filter selection (1 to 9). Determines whether the corresponding frequency range is bypassed or not:
1 is the lowest frequency range, 9 is the highest frequency range
X4%
— Parametric EQ filter frequency. Default values: 62 Hz (filter 1), 125 Hz (filter 2), 250 Hz (filter 3), 500 Hz (filter 4),
1000 Hz (filter 5), 2000 Hz (filter 6), 4000 Hz (filter 7), 8000 Hz (filter 8), 16000 Hz (filter 9)
X4^
— Parametric EQ Q value, multiplied by 1000 (from 707 to 15000; default 2000)
SSP 7.1 • SIS Commands 92