Extron Electronics SSP 7.1 User Guide - Manual (Page 57)

Drop-down Menus
The menu bar at the top of the window provides additional
tools and options. The four top-level headings are
File ,
Device , Options , and Help (see figure at right).
File
The File menu options allow you to save changes made to the
configuration of the SSP 7.1, whether you are running the software
in Live or Emulate mode. The current configuration can be saved as
an *.esp file, which can be opened, further modified, saved, or saved
by a different name. The File menu has five options.
New — If the software is in Emulate mode, you can save the
configuration changes you have made to a new file by clicking on
New. This creates a new file with the default settings that can be
saved in any directory on your network.
Open — Opens an existing file. The current settings of the SSP 7.1 are replaced by the
values in the file being opened.
Save — If the file that is currently being modified in Emulate mode has already been named
and saved, this option saves any updates to the same file.
Save As — If the file that is currently being modified in Emulate mode has not been
named, this allows you to name the file, place it in any directory on your network, and save
it.
Exit — Clicking on Exit shuts down the program.
Changes to the configuration of the SSP 7.1 made in Live mode are saved as they are made.
Exiting the program after a Live mode session, leaves all changes from that session in effect.
To restore all values to factory defaults, select the Reset... option in the
Device menu on the
following page.
SSP 7.1 • Setup and Control Software 51