ADTRAN TSU 120e - Manual (Page 104)

Chapter 8. Telnet/Terminal Menus
8-6 TSU 120 User Manual 61202129L1-1
Figure 8-3. Unit Access Table
Add New Unit
This adds a new device to the unit access table.
• You must enter a device U NIT ID , P ASSCODE , U NIT T YPE , and
P OLLED F LAG .
• Unit type can be S TANDARD (which supports any TSU/TDU
Multiplexer and the ISU 512) or TSU S TANDALONE (a single
port TSU with no option card slot).
• You may select a passcode of 0 to 9999 for each device or
DEFAULT . This results in the default passcode being used
(defined as 0022 in Figure 8-3).
• Traps are normally sent from the unit in alarm to the TSU
120. For units in the Unit Access Table that are not chained
directly to the TSU 120 but are managed over Inband or the
FDL, traps are not automatically forwarded.
• Polling must be enabled on the TSU 120 for these units in or-
der to receive Traps on the NMS. The TSU 120 can be con-
figured to poll selected units for traps by enabling the
polled option when adding or modifying a unit entry.
_____________________________Unit Access ____________________________
Unit ID Passcode Type Polled PollStatus
20 DEFAULT Standard No
3 0033 Standard Yes UP
6 0095 TSU Stand Alone No
8 0022 Standard Yes UP
1) Add New Unit
2) Modify Unit
3) Delete Unit
4) Default Unit Passcode 0022
5) OK