ADTRAN TSU 120e - Manual (Page 87)

Chapter 6. Utility Menu
61202129L1-1 TSU 120 User Manual 6-5
If an out-of-range number is entered, the unit assumes the
upper limit number of
999 .
Set the Unit Identification
In the U NIT ID M ENU (item 4) under the U TIL M ENU , enter any
value between 2 and 999 . The number 1 is reserved for the PC.
Press Enter to record the Unit ID number and to establish its
availability for operation by remote control. The unit proceeds
to the
S ET C ONTROL P ORT
prompt.
No Unit ID Desired
Press Enter at the U NIT ID PROMPT
without entering any numbers.
The unit will not be able to be operated by remote control.
Software Revision (Software Rev)
This menu provides access to the display of the current soft-
ware revision level loaded into the base unit controller. This
information is required when requesting assistance from
ADTRAN Customer Service or when updates are needed.
Press Cancel to exit.
Port Utility (Option Ports)
This menu provides access to the display of the current soft-
ware information for each port installed in the unit. This infor-
mation is required when requesting assistance from ADTRAN
customer service or when updates are needed.
ENET Address (TSU 120e only)
Displays the Ethernet address for the 10BaseT port.
Serial Number
Displays the serial number of the unit.
CMD Mode
Reserved for factory use.