ADTRAN TSU 120e - Manual (Page 71)

Chapter 5. Configuration Menu
61202129L1-1 TSU 120 User Manual 5-13
IP ADDRESS This is the IP address that uniquely identifies
the TSU 120 on a TCP/IP network.
This address is composed of four decimal
numbers, each in the range of 0 to 255,
separated by periods. This value is used for
either the 10BaseT Ethernet or SLIP interface,
depending on the IP interface setting
(10BaseT is only available in the TSU 120e).
SUBNET
MASK This defines which part of a destination IP
address is the Network number. It is used
along with the TSU 120 IP address to
determine which nodes must be reached
through the default IP Gateway. This value is
ignored when the IP interface is set to
SLIP .
DEFAULT
ROUTER All IP Packets destined for nodes not on the
TSU 120 unit’s local network are not
forwarded through this IP address.
Normally, this address defines a router
connected to the TSU 120 unit’s local
network. This value is ignored when the IP
interface is set to
SLIP .
SLIP RATE This sets the baud rate for the Chain-In port
when used as the SLIP connection for SNMP
management.
Choices: 1200, 2400, 4800, 9600, 19200, 38400
Kbps
SLIP FLOW
CTL This is used to activate flow control on the
Chain-In port when used as the SLIP
interface. Hardware mode uses RTS and CTS.
Choices: None, Hardware
PROXY TRAPS This determines whether or not traps will be
forwarded from units being “proxied” for.
Choices: Enable, Disable
Menu Item Description