Proface FP3900 - 19 Flat Panel" - Manual (Page 36)

FP-2500/FP-2600 Series User Manual
2.6 FP Dimensions
2-17
2.6.3 Installation Fasteners
2.6.4 FP Panel Cut Dimensions
Panel
301.5 [11.87 ] +1
0 +0.04
0
227.5 [8.96 ]
+0.04 0
+1 0
under 4-R3
Unit: mm [in.]
• Panel thickness should be between 1.6mm [0.06in.] and
10.0mm [0.4in.]. Panel’s thickness should be based on
the level of panel strength required.
• Check that the installation panel or cabinet's surface is
flat, in good condition and has no jagged edges.
• If desired, metal reinforcing strips can be attached to
the inside of the panel, near the Panel Cut, to increase
the panel’s strength.
3.1.1 Installation Procedure
• Be sure to create the correct sized panel cut required to
install the FP, using the installation dimensions given.
FP
Panel Cut
11
[0.43]
16 [0.63]
31 [1.22]
19.5 [0.77]
M5
10f
Unit : mm [in.]