Proface FP3900 - 19 Flat Panel" - Manual (Page 38)

FP-2500/FP-2600 Series User Manual 3-1
3.1 Installation
3.1 Installation
Chapter 3
Installation and Wiring
1. Installation
2. Wiring
3. Operation Mode Setup
and Display Positioning
3.1.1 Installation Procedures
Follow the steps given below when installing the FP.
Check the Installation Gasket’s Seating
It is strongly recommended that you use the installation gasket, since it absorbs vibration
in addition to repelling water.
Place the FP on a level surface with the display panel facing downward. Check that the
FP unit’s installation gasket is seated securely into the gasket’s groove, which runs
around the perimeter of the panel’s frame.
For details about installing the gasket, refer to
• Before installing the FP into a cabinet or panel, check that the in-
stallation gasket is securely attached to the unit.
• A gasket which has been used for a long period of time may have
scratches or dirt on it, and can lose much of its dust and drip resis-
tance. Be sure to change the gasket periodically (or when scratches
or dirt become visible).
• Be sure to use gasket model GP570-WP10-MS.
• Be sure the gasket's seam is not inserted into any of the unit's cor-
ners, only in the straight sections of the groove. Inserting it into a
corner may lead to its eventually tearing.
• To ensure the installation gasket’s maximum level of moisture resis-
tance, be sure the gasket’s seam is inserted as shown into the panel’s
bottom face.
6.1.2 Installation Gasket Check/Replacement
Gasket
Rear face