Watlow ANAWIN 2 - Manual (Page 11)

Installation and Setup
AnaWin User’s Guide 1-3
Good engineering practices, electrical codes, and insurance regulations
require you to use independent external safety devices to prevent
potentially dangerous or unsafe conditions. Use of AnaWin does not
eliminate the need for appropriate external, independent safety devices.
For additional process safety, use AnaWin to automatically reload your
desired operating parameters after a power failure.
Please contact Watlow Anafaze immediately if you have questions
about system safety.
Installation
To install AnaWin, follow these steps:
1. Click on the Windows95 Task Bar with the right mouse button,
then choose Properties, then Autohide.
2. Insert the disk labeled AnaWin Disk 1 in the floppy drive.
3. Click on Start and Run at the bottom of the screen.
4. Type a:\setup or b:\setup.
5. The Setup program prompts you through the installation process.
Follow the instructions on the screen.
The first time you run AnaWin, you are prompted to enter your
serial number. You must enter the serial number printed on
AnaWin disk 1. You will also need this serial number any time you
request technical support.
AnaWin loads the Configuration program and displays the controller
setup screen. Refer to “System Setup,” below, for instructions on using
the controller setup screen.
System Setup
The controller setup screen, shown in Figure 1-2, allows you to set the
software parameters to match the controller(s). When you first install
AnaWin, this screen appears automatically after a successful install. If
AnaWin has been previously installed, you can access the controller
setup screen by selecting Configure from the System menu.