Watlow ANAWIN 2 - Manual (Page 15)

Installation and Setup
AnaWin User’s Guide 1-7
FIGURE 1-4 Channel Grouping Setup Screen
Group Parameters
• Name: Displays the name of the group currently selected in the list.
• New: Lets you create a new group to add to the list.
• Rename: Lets you rename a group.
• Delete: Lets you delete a group.
Add and Remove Buttons
These buttons allow you to add channels to and remove channels from a
group.
Add: Lets you add the sequence of channels defined by the Start
Channel and End Channel fields to the current group.
Remove: Lets you remove the channels selected in the list in the Group
panel from the current group.
Available Controllers and Channels
The Available panel allows you to select a controller and block of
channels for grouping. The Start Channel and End Channel fields
define the sequence of channels to add to the group. Click Add to add
these channels to the group. When you add a sequence of channels, the
channel names are listed in the Group panel.
Other Configuration Options
You can perform the following optional configuration options.
• Automatically set up each ModBus address.
• Configure communications options.
• Customize displayed parameter, channel, and/or digital I/O names.