Ramp soak setup, Other – Watlow ANAWIN 2 User Manual
Page 47
Setting Channel Parameters
AnaWin User’s Guide 5-7
FIGURE 5-9
Channel Setup Alarm Tab
Other
Use the Other tab, shown in Figure 5-10, to edit additional output
parameters.
FIGURE 5-10
Channel Setup Other Tab
Ramp Soak Setup
AnaWin’s ramp/soak feature turns your controller into a powerful and
flexible batch controller, which you can program to change a process’
setpoint in a preset pattern over time. This pattern, or temperature
profile, consists of up to twenty segments. During a segment, the
temperature goes from the previous segment’s setpoint to the current
segment’s setpoint.
•
If the current segment’s setpoint is larger or smaller than the previ-
ous segment’s setpoint, the segment is called a ramp.
•
If the current segment’s setpoint is the same as the previous seg-
ment’s setpoint, the segment is called a soak.