Watlow ANAWIN 2 - Manual (Page 48)

5-8 AnaWin User’s Guide
Setting Channel Parameters
Each segment can have up to two triggers (digital inputs). If enabled,
these triggers must be true before the segment can start. When neither of
the triggers is true, the profile is in the trigger wait state. You can use the
same trigger for more than one loop or one profile.
Using AnaWin’s ramp/soak feature, you can:
• Assign new ramp/soak profiles.
• Synchronize loops.
• Modify segment times.
• View and modify profiles.
• Save profiles to disk.
Your controllers must include the ramp/soak option in order to use
AnaWin’s ramp/soak feature. In addition, you must enable ramp/soak in
the Configuration program—by selecting the Ramp Soak Option check
box on the Controller Setup screen—in order to activate the ramp/soak
screens. If you do not select this option, the ramp/soak screens will not
be available.
Assigning Profiles to Loops
Select Ramp Soak Setup from the Channel Setup menu to display the
Ramp Soak Assignment screen, shown in Figure 5-11. From this screen,
you assign profiles to loops.
NOTE
If you do not have any ramp/soak controllers connected to your sys-
tem, you will get an error message when you select Ramp Soak
Setup.
FIGURE 5-11 Ramp Soak Assignment Screen
The Ramp Soak Assignment screen consists of a table in which each
row corresponds to a channel.