Watlow ANAWIN 2 - Manual (Page 43)

Setting Channel Parameters
AnaWin User’s Guide 5-3
NOTE
If Allow Channel Grouping is selected on the Controller Setup
screen, only the channels assigned to the current group will be
available for selection.
Copy to channels
Click Copy to Channels to copy the displayed channel’s setup to another
channel. This feature enables fast and easy channel setup. You cannot
copy the setup of a pulse channel to a non-pulse channel, and vice versa.
When you click Copy to Channels, the channel list shown in Figure 5-3
appears. Highlight the desired channel(s), then click OK. The
parameters from the current channel are copied to each of the selected
channels.
FIGURE 5-3 Selecting Channels to which to Copy Parameters
Control Mode and Ramp/Soak Status
The right side of the Channel Setup screen’s channel summary area
displays the control modes Manual, Auto, or Tune. Use the Control tab
in the Channel Setup Tabs panel to change the control made. Refer to
“Control,” under “Channel Setup Tabs,” for details. If Manual mode is
selected, you can use the Heat PID and Cool PID fields to change the
power percentages; otherwise, if a ramp/soak profile is assigned to the
channel, the ramp/soak status—Start, Run, or Hold—is displayed. Refer
to “Control,“under “Channel Setup Tabs,” for details about how to set
the ramp/soak status.
Real-time Trend Plot
The real-time trend plot on the right of the Channel Setup screen
provides real-time graphic trending.