Brocade Mobility Access Point System Reference Guide (Supporting software release 5.5.0.0 and later) User Manual
Page 143
Brocade Mobility Access Point System Reference Guide
133
53-1003100-01
5
Select the + Add Row button to populate the table. Add the IP address and mask of the Network(s)
participating in OSPF. Additionally, define the OSPF area (IP address) to which the network belongs.
10. Set an OSPF Default Route Priority (1 - 8,000) as the priority of the default route learnt from
OSPF.
11. Select the Area Settings tab.
An OSPF Area contains a set of routers exchanging Link State Advertisements (LSAs) with others in
the same area. Areas limit LSAs and encourage aggregate routes.
FIGURE 43
Network - Area Settings tab
12. Review existing Area Settings configurations using:
13. Select Add to create a new OSPF configuration, Edit to modify an existing configuration or
Delete to remove a configuration.
Area ID
Displays either the IP address or integer representing the OSPF area.
Authentication Type
Lists the authentication schemes used to validate the credentials of dynamic route connections.
Type
Lists the OSPF area type in each listed configuration.