Brocade Mobility Access Point System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 633)

Brocade Mobility Access Point System Reference Guide 623
53-1003100-01
10
7. Configure the AAA TACACS Policy to use with this authentication policy. Use the
drop-down to select a configured AAA TACACS policy.
8. Select OK to update the configuration. Select Reset to revert to the last saved configuration.
Setting the SNMP Configuration
Getting Started with the Mobile Computer
The access point can use Simple Network Management Protocol (SNMP) to interact with wireless
devices. SNMP is an application layer protocol that facilitates the exchange of management
information. SNMP enabled devices listen on port 162 (by default) for SNMP packets from their
management server. SNMP uses read-only and read-write community strings as an authentication
mechanism to monitor and configure supported devices. The read-only community string is used to
gather statistical data and configuration parameters from a supported wireless device. The
read-write community string is used by a management server to set device parameters. SNMP is
generally used to monitor a system’s performance and other parameters.
To define SNMP management values:
1. Select Configuration > Management.
2. Select SNMP from the list of Management Policy options in the upper, left-hand, side of the UI.
SNMP Version Encrypted Authenticated Default State
SNMPv2 No No Enabled
SNMPv3 Yes Yes Enabled