Brocade Mobility Access Point System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 433)

Brocade Mobility Access Point System Reference Guide 423
53-1003100-01
6
FIGURE 14 WLAN - Client Settings screen
4. Define the following Client Settings for the WLAN:
Enable
Client-to-Client
Communication Select this option to allow client to client communication within this WLAN. The default is enabled,
meaning clients are allowed to exchange packets with other clients. Disabling this setting does not
necessarily prevent clients on other WLANs from sending packets to this WLAN, but as long as this
setting is disabled on the other WLAN, clients are not permitted to interoperate.
Wireless Client Power Use this parameter to set the maximum transmit power (from 0 - 20 dBm) available to wireless
clients for transmission. The default value is 20 dBm.
Wireless Client Idle Time Set the maximum amount of time wireless clients are allowed to be idle within this WLAN. Set the
idle time in either Seconds (60 - 86,400), Minutes (1 - 1,440), Hours
(0 - 24) or Days (0 - 1). When this setting is exceeded, the client is no longer able to access
resources and must re-authenticate. The default value is 1,800 seconds.
Max Firewall Sessions per
Client Select this option to set the maximum number of sessions (from 10 - 10,000 clients) over the
Firewall. When enabled, this parameter limits the number of simultaneous sessions allowed by the
Firewall per wireless client. This feature is disabled by default.