Brocade Mobility Access Point System Reference Guide (Supporting software release 5.5.0.0 and later) User Manual
Page 398
388
Brocade Mobility Access Point System Reference Guide
53-1003100-01
5
FIGURE 216
Device Overrides - Advanced Profile MINT screen - Add VLAN screen
Set the following VLAN parameters to complete the MINT configuration:
Select OK to save the updates and overrides to the MINT Protocol configuration. Select Reset to
revert to the last saved configuration.
Select the Advanced Miscellaneous menu item.
FIGURE 217
Device Overrides - Miscellaneous screen
VLAN
Define a VLAN ID from 1 - 4,094 used by peer controllers for interoperation when supporting
the MINT protocol.
Routing Level
Use the spinner control to define or override a routing level of either 1 or 2.
Link Cost
Use the spinner control to define or override a link cost from 1 - 10,000. The default value is
100.
Hello Packet Interval
Set or override an interval in either Seconds (1 - 120) or Minutes (1 - 2) for the transmission of
hello packets. The default interval is 4 seconds.
Adjacency Hold Time
Set or override a hold time interval in either Seconds (2 - 600) or Minutes (1 - 10) for the
transmission of hello packets. The default interval is 13 seconds.