Brocade Mobility Access Point System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 458)

448 Brocade Mobility Access Point System Reference Guide
53-1003100-01
6
8. Configure the following intended Upstream Rate Limit parameters for wireless client traffic:
9. Set the following Upstream Random Early Detection Threshold settings for each access
category. An early random drop is conducted when the amount of tokens for a traffic stream
falls below the set threshold for wireless client traffic.
Enable Select this radio button to enable rate limiting for data transmitted from access point radios to
associated clients. Enabling this option does not invoke rate limiting for data traffic in the
downstream direction. This feature is disabled by default.
Rate Define an upstream rate limit from 50 - 1,000,000 kbps. This limit constitutes a threshold for the
maximum the number of packets transmitted or received from clients (from all access categories).
Traffic exceeding the defined rate is dropped and a log message is generated. The default setting is
1000 kbps.
Maximum Burst Size Set a maximum burst size from 2 - 1024 kbytes. The smaller the burst, the less likely the upstream
packet transmission will result in congestion for wireless client traffic. By trending the typical
number of ARP, broadcast, multicast and unknown unicast packets over a period of time, the
average rate for each access category can be obtained. Once a baseline is obtained, administrators
should then add a minimum of a 10% margin to allow for traffic bursts at the site. The default burst
size is 64 kbytes.
Background Traffic Set a percentage for client background traffic in the upstream direction. This is a percentage of the
maximum burst size for low priority traffic. Background traffic exceeding the defined threshold is
dropped and a log message is generated. Background traffic consumes the least bandwidth of any
access category, so this value can be set to a lower value once a general upstream rate is known by
the network administrator (using a time trend analysis). The default threshold is 50%.
Best Effort Traffic Set a percentage for client best effort traffic in the upstream direction. This is a percentage of the
maximum burst size for normal priority traffic. Best effort traffic exceeding the defined threshold is
dropped and a log message is generated. Best effort traffic consumes little bandwidth, so this
value can be set to a lower value, once a general upstream rate is known by the network
administrator (using a time trend analysis). The default threshold is 50%.
Video Traffic Set a percentage for client video traffic in the upstream direction. This is a percentage of the
maximum burst size for video traffic. Video traffic exceeding the defined threshold is dropped and a
log message is generated. Video traffic consumes significant bandwidth, so this value can be set to
a higher value once a general upstream rate is known by the network administrator (using a time
trend analysis). The default threshold is 25%.
Voice Traffic Set a percentage for WLAN voice traffic in the upstream direction. This is a percentage of the
maximum burst size for voice traffic. Voice traffic exceeding the defined threshold is dropped and a
log message is generated. Voice applications consume significant bandwidth, so this value can be
set to a higher value once a general upstream rate is known by the network administrator (using a
time trend analysis). The default threshold is 0%.