Brocade Mobility Access Point System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 293)

Brocade Mobility Access Point System Reference Guide 283
53-1003100-01
5
NOTE
A blue override icon (to the left of a parameter) defines the parameter as having an override applied.
To remove an override, go to the Basic Configuration screen’s Device Overrides field and select Clear
Overrides. This will remove all overrides from the device.
Refer to the WAN (3G) Backhaul configuration to specify WAN card settings:
Define or override the following authentication parameters from within the Basic Settings field:
24. Use the NAT Direction field to specify the NAT direction used with the access point’s WAN card.
Options include Inside, Outside or None. The default is None.
Configure the Inbound IP Firewall Rules. Use the drop-down menu to select a firewall (set of IP
access connection rules) to apply to the PPPoE client connection. If a firewall rule does not exist
suiting the data protection needs of the PPPoE client connection, select the Create icon to define a
new rule configuration or the Edit icon to modify an existing rule.
Select the VPN Crypto Map to use with this WWAN configuration. Use the drop-down menu to apply
an existing crypt map configuration to this WWAN interface.
Configure the WWAN Default Route Priority. Use the spinner control to set the Default Route Priority
for the WWAN default route. Select from 1 - 8,000. The default setting is 3,000.
Select OK to save or override the changes to the Advanced Settings screen. Select Reset to revert
to the last saved configuration.
PPPoE Configuration
Profile Interface Configuration
PPP over Ethernet (PPPoE) is a data-link protocol for dialup connections. PPPoE allows the access
point to use a broadband modem (DSL, cable modem, etc.) for access to high-speed data and
broadband networks. Most DSL providers are currently supporting (or deploying) the PPPoE
protocol. PPPoE uses standard encryption, authentication, and compression methods as specified
by the PPPoE protocol. PPPoE enables Mobility supported controllers and access points to
establish a point-to-point connection to an ISP over existing Ethernet interface.
WAN Interface Name Displays the WAN Interface name for the WAN 3G Backhaul card.
Reset WAN Card If the WAN card becomes unresponsive or is experiencing other errors click the Reset WAN Card
button to power cycle and reboot the WAN card.
Enable WAN (3G) Select this option to enable 3G WAN card support on the device. A supported 3G card must be
connected to the device for this feature to work.
Username Provide your username for authentication support by your cellular data carrier.
Password Provide your password for authentication support by your cellular data carrier.
Access Point Name (APN) Enter the name of the cellular data provider if necessary. This setting is needed in areas with
multiple cellular data providers using the same protocols such as Europe, the middle east and Asia.
Authentication Type Use the drop-down menu to specify authentication type used by your cellular data provider.
Supported authentication types are None, PAP, CHAP, MSCHAP, and MSCHAP-v2.