Brocade Virtual ADX XML API Programmer’s Guide (Supporting ADX v03.1.00) - Manual (Page 315)

Brocade Virtual ADX XML API Programmer’s Guide 305
53-1003248-01
Data structures
4
StpOtherInfo
This is a high-level description of an STP summary.
StpSummary
This is a high-level description of an STP summary.
SwitchIP
This structure is the high-level description of a management IP configuration on the switch.
TABLE 745 Attributes
Name Type Presence Rules Description
enableStpParam Boolean Enables STP.
stpInfo Stp The data structure containing the STP information.
ports InterfaceID [ ] The interface number.
stpTypr stpTypeEnum The STP type.
vLanID String The VLAN ID.
enableDualMode twoWayToggleEnum Enable or disable dual mode.
autoEnable twoWayToggleEnum The value set by the system software.
enableRapidPVST twoWayToggleEnum Enable or disable rapid PVST.
enablePvst twoWayToggleEnum Enable or disable PVST.
TABLE 746 Attributes
Name Type Presence Rules Description
globalStp Stp
portStp PortStp
TABLE 747 Attributes
Name Type Presence Rules Description
Ip string Optional The IP address
subnetMask string Optional Valid only for IPv4
addresses.
Either the
subnetMask or
subnetMaskLength
must be present.
Both cannot be
present together. The IP subnet mask.