Brocade Virtual ADX XML API Programmer’s Guide (Supporting ADX v03.1.00) - Manual (Page 770)

760 Brocade Virtual ADX XML API Programmer’s Guide
53-1003248-01
List of Error Messages
A
NET_VLAN_ROUTER_INT_CONFIG_FAILED The route interface cannot be configured. No physical
interfaces can be added to VLAN %d Please add physical
interfaces to the VLAN and try again.
NET_VLAN_ROUTER_INT_IN_USE The specified router interface %d has been configured on
another VLAN. Please specify a different router interface.
NET_VLAN_ROUTER_INT_INVALID The specified Router interface %d is invalid. Please
specify a valid value in the range of 1 to %d.
NET_VLAN_SINGLE_STP_RESERVED The specified VLAN ID %d is reserved for a single STP
VLAN. Please specify a different VLAN ID.
NET_VLAN_TRUNK_DUAL_PORTS The specified port(s) "%s" are dual mode port(s). Please
specify different ports
NET_VLAN_TRUNK_PORT_NOT_MEMBER_OF_DEFAU
LT The specified trunk port "%s" is not a member of the
default VLAN. Please specify a different trunk port.
NET_VRID_CONFIG_FAILED The VRID configuration failed. The router type cannot be
an owner in VRRP-E and VRRP-E-IPv6.
NET_VRID_SET_FAILED VRID %u is already used by another VRRP interface in
same CAM space. Remove this conflicting VRID %u and
recreate it using another VRID.
NET_VRRP_ADX_REACHED_MAX_VRID The VRID configuration failed. The maximum number of
VRIDs %d has been reached in the Brocade Virtual ADX
device.
NET_VRRP_ADX_REACHED_MAX_VRID_PER_INTERFA
CE The VRID configuration has failed. The maximum of %s
routers %u for this interface has been exceeded.
NET_VRRP_DEACTIVATE_VIRTUAL_ROUTER The VRRP configuration Failed. Please deactivate this
virtual router for VRID %u and try again.
NET_VRRP_EXCEED_MAX_VIRTUAL_IP_CONFIG The Virtual IP address configuration failed. The maximum
IP address limit %u is exceeded.
NET_VRRP_INVALID_CONFIG_ON_LOOPBACK_INTER
FACE The VRRP or VRRP-E is not supported on Loopback or
Management interface. Please specify a valid Ethernet or
Virtual Interface.
NET_VRRP_INVALID_INTERVAL The %s Interval value is invalid. Please specify a %s
Interval value in the range of %d to %d.
NET_VRRP_INVALID_PRIORITY The %s priority value is invalid. Please specify a %s
priority value in the range of %d to %d.
NET_VRRP_INVALID_TRACK_PORT_CONFIGURATION The group virtual port cannot be configured as track port.
Please specify valid Ethernet or Virtual interface port.
NET_VRRP_INVALID_TRACK_TRUNK_PORT_CONFIGU
RATION The Virtual or Group virtual port cannot be configured as
track trunk port. Please specify valid Ethernet port.
NET_VRRP_INVALID_VRID The VRID value is invalid or does not exist. Please specify
a VRID value in the range of 1 to 255.
NET_VRRP_IP_SETTING_FAILED The VRRP IP Address setting failed. An IP address %I in
the same subnet is not defined in this interface. Please
specify a valid IP Address.
TABLE 109 List of error messages
Error String Message