Brocade Virtual ADX XML API Programmer’s Guide (Supporting ADX v03.1.00) - Manual (Page 782)

772 Brocade Virtual ADX XML API Programmer’s Guide
53-1003248-01
List of Error Messages
A
SLB_ENABLE_STICKY_ACL_ID_FAILED Enabling Sticky ACL failed. To enable Sticky ACL, you must
specify a sticky ACL ID value.
SLB_ENABLE_STICKY_PARAMS_MISSING The enable client subnet sticky operation failed. To
enable client subnet sticky operation, you must specify a
subnet mask or a prefix length.
SLB_ENABLE_TCP_OFFLOAD_FAILED Enabling the TCP offload has failed for the port %d. You
need to enable CSW before enabling this feature.
SLB_ERR_BIND_NON_PING_TO_VIP Only ICMP type health check nodes can be bound to a VIP
port. Please specify a valid node.
SLB_ERR_MAX_DEPTH_NODE The node has reached the maximum allowed depth. The
maximum allowed depth for the node is %d.
SLB_ERR_MAX_ENTRIES Cannot define any more health check elements. The
maximum limit for defining health check elements has
been reached.
SLB_ERR_MAX_INVALID The node range value is invalid. Please specify a value in
the range of %u to %u.
SLB_ERR_NODE_IN_USE The health check element is bound. Please unbind the
health check element.
SLB_ERR_NODE_REFERENCE The health check element is being referenced. Please
specify a non-referenced health check element name.
SLB_ERR_NOT_HTTP_SSL_PROTOCOL The content match applies only to HTTP or SSL protocols.
Please specify the HTTP or SSL protocol.
SLB_ERR_UNBIND_WRONG_NODE The specified health check element "%s" is wrong and
cannot be unbound. Please specify a valid health check
element name.
SLB_ERROR_CONFIG_COMPLETE_NON_SSL The 'use-complete' option applies only to the SSL protocol.
Please specify the SSL protocol.
SLB_ERROR_CONFIG_HEALTHCHECK_CONTENT The health check 'content-check' policy is not found.
Please configure the destination IP address before you
configure the port.
SLB_ERROR_CONFIG_HEALTHCHECK_PROTOCOL The port is not configured. Please configure the port
before you specify the protocol.
SLB_ERROR_CONFIG_RADIUS The RADIUS protocol cannot be configured with the port
%d. Please specify a valid port.
SLB_ERROR_CONFIG_USERNAME_NON_RADIUS The username, password, key, NAS-IP or NAS-Port applies
only to the DNS protocol. Please specify the RADIUS
protocol.
SLB_ERROR_CONFIG_ZONE_NON_DNS The 'zone' or 'addr-query' applies only to the DNS protocol.
Please specify the DNS protocol.
SLB_ERROR_L7_CHECK_ON_PORT The port is missing or the protocol for an unknown port is
missing. Please specify a valid port or protocol for an
unknown port before enabling the Layer7 check.
SLB_ERROR_L7_PROTOCOL_SUPPORT The specified protocol %d is currently not supported for
the unknown port Layer7 check. Please specify a valid
and supported protocol.
TABLE 109 List of error messages
Error String Message