LumaSense Technologies INNOVA 1303 User Manual
Page 53
Chapter 4
________________________________________________________________________
_______________________________________________________________________
BE1085-14
1303 Multipoint Sampler and Doser
LumaSense Technologies A/S
Page 53 of 60
4.2.2
Sampler System Jobs
These jobs control the 1303’s sampler system. Further information
about these jobs is given in
section 3.5
.
Table 4.2 The interface jobs which control the 1303’s sampler system.
Job Header
Data
Effect on 1303
Open_Sampling_Valve
Up to 6 sampling-
valve numbers.
Opens the speci-
fied sampling
valves.
Connect_Sampling_Valve To_Monitor
To_Sampling_Pump
Routes the air-
sample either to
the Gas Monitor,
or via the sam-
pling pump to the
Waste Air Out-
let.
Sampling_Pump
On
Off
Starts/stops the
sampling pump.
4.2.3
Doser System Jobs
These jobs control the dosing function of the 1303. For further infor-
mation about the calibration of the doser system, refer to
section 3.4
.
For further information about using the doser system, see
section 3.6
.