GW Instek GDS-122 User Manual - Manual (Page 22)

Using the Oscilloscope
43
Move the
cursor left
Move the
cursor right
Move the
horizontal
position left
Move the
horizontal
position right
Display overview
(CH1, cursor 2) T1
Cursor
T2 - T0 time
T1 - T0 time
T1 - T2 time
& frequency
Cursor menu
T0
(center)
T2
Cursor
36B
Running voltage cursor measurements
Overview The voltage cursor function measures and updates
the following five types of voltage difference.
• Between cursor 1 and cursor 2
• Between cursor 1 and CH1 center point
• Between cursor 2 and CH1 center point
• Between cursor 1 and CH2 center point
• Between cursor 2 and CH2 center point
Source signal CH1 input, CH2 input
1. Make sure the waveform appears. Voltage cursor
panel operations
2. Press the MENU key and
select the CURS MEAS menu
using the Up/Down keys.
MENU CURS MEAS
GDS-122 User Manual
44
3. Press F1 (Type) repeatedly to
select the Voltage cursor. The
cursors appear as horizontal
purple lines located at the
center of the display.
Voltage
Type
F1
4. Press F2 (Source) repeatedly
to select the source channel.
CH1
Source
F2
5. Press the OSC OPTION key
repeatedly until the following
menu appears.
OSC
OPTION
– Time
– Cursor V1 (or V2)
6. Use the arrow keys to move the cursor or
horizontal position.
OSC
OPTION
Move the
cursor up
Move the
cursor down
Move the
horizontal
position left
Move the
horizontal
position right
Display overview
(CH1, cursor 2)
V2 - center
V1 - center
|V1 - V2|
Cursor menu
V1
Cursor
V2
Cursor