GW Instek GDS-122 User Manual - Manual (Page 46)

Using the Multimeter
91
16B
Measuring Diode
Range 0V to 1.5V
Panel operations 1. Press the R switch. If a warning
message appears, press any key to
resume measurement.
2. Press the AUTOSET key repeatedly
to select the diode measurement.
AUTOSET
3. The diode measurement screen appears.
Battery level
Measurement
unit
Scaling factor
F1-F3 menu
(not used)
Manual range
Run/Stop
Measurement
result
Meter
Diode
4. Connect the test leads to the
terminals:
COM for the black lead
V/
Ω/C for the red lead
5. The measurement result will be constantly
updated in the display.
Freezing the
measurement
To freeze the measurement, press the
RUN/STOP key. The measurement
result will be retained and the
indicator at the top right corner of the
display changes to STOP. To unfreeze,
press the RUN/STOP key again. RUN/STOP
RUN
STOP
GDS-122 User Manual
92
17B
Measuring Continuity
Conditions < 50
Ω (beeping)
Panel operations 1. Press the R switch. If a warning
message appears, press any key to
resume measurement.
2. Press the AUTOSET key repeatedly
to select the continuity
measurement.
AUTOSET
3. The continuity measurement screen appears.
Battery level
Measurement
unit
Scaling factor
F1-F3 menu
(not used)
Manual range
Run/Stop
Measurement
result
Meter
Continuity
4. Connect the test leads to the
terminals:
COM for the black lead
V/
Ω/C for the red lead
5. If the GDS‐122 confirms continuity (the
impedance is less than 50
Ω), the beeper
sounds.
Freezing the
measurement
To freeze the measurement, press the
RUN/STOP key. The measurement
result will be retained and the
indicator at the top right corner of the
display changes to STOP. To unfreeze,
press the RUN/STOP key again. RUN/STOP
RUN
STOP