GW Instek GDS-122 User Manual - Manual (Page 37)

Using the Oscilloscope
73
2. Hold the mouse and drag the waveform
sideways.
Changing the vertical position
Click the channel label at the left side of the
waveform and drag the waveform up or down.
Changing the
waveform scales
Before changing the scales, make sure that the
correct waveform is selected (highlighted) in the
lower left corner of the screen (example: CH1).
Changing the horizontal scale
Select the horizontal scale using
the list at the right side of the
screen. You can select the scale
either by searching in the Scale
column or by clicking the
Position arrows.
GDS-122 User Manual
74
Changing the vertical scale
Select the vertical scale using
the list at the right side of the
screen. You can select the scale
either by searching in the Scale
column or by clicking the
Position arrows.
Viewing the
automatic
measurement
results
Before viewing the measurement results, make
sure that the correct waveform is selected
(highlighted) in the lower left corner of the screen
(example: CH1).
The measurement result
is updated in the lower
right corner of the
screen. Three parameters
are listed.
• Period: measures the waveform period in ms.
• Freq: measures the waveform frequency in
kHz.
• PK‐PK: measures the peak to peak voltage in V.