KANOMAX 6501 series Climomaster - Manual (Page 17)

16 Getting Started
Duct Shape / Size Input
Before measuring the volumetric flow rate, the duct shape and size
settings must be entered. Up to 25 different duct types can be
registered in this instrument.
Select a duct type from the registered duct types to measure the air
flow rate.
Press to enter the Main Menu.
Use to select ”2. DUCT TYPE”.
Press .
<To Set Duct ENTRY No.>
You can choose a memory address from 1 to 25 to store the duct
data in.
Use to select “1. ENTRY No.”
and press .
Use to select ENTRY No. and
press .
<To Set Duct SHAPE (RECTANGLE/CIRCLE)>
Use to select “2. SHAPE” and press .
Use to select “RECTANGLE” or “CIRCLE” and press .
Rectangular Duct Circular Duct
aaaaaaa DUCT a TYPE
1.ENTRY a No. aaaaaaaa 1
2.SHAPE aaaaC IRCLE
3.DIAMETER aaaaaaa 300
4.UNIT(mm/inch) aaa mm
6.SAVE
a INFO
aaaaaaa DUCT a TYPE
1.ENTRY a No. aaaaaaaa 1
2.SHAPE aaaaR ECTANGLE
3.W a SIZE aaaaaaaaaaa -
4.H a SIZE aaaaaaaaaaa -
5.UNIT(mm/inch) aaa mm
6.SAVE a INFO
aaaaaaa DUCT a TYPE
1.ENTRY a No. aaaaaaaa1
2.SHAPE aaaa RECTANGLE
3.W a SIZE aaaaaaaaaaa -
4.H a SIZE aaaaaaaaaaa -
5.UNIT(mm/inch) aaa mm
6.SAVE a INFO
MENU aa 1.NORMAL
aaaaaa2 .DUCT a TYPE
aaaaaa 3.CALCULATION
aaaaaa 4.FLOW a RATE
aaaaaa 5.DATA a OUTPUT
aaaaaa 6.DATA a CLEAR
aaaaaa 7.UTILITY
aaaaaa 8.PRESSURE a ZERO