Innotech eServer - Manual (Page 108)

eServer Setup and Site Installation Instructions
Page 108 © Mass Electronics Pty Ltd 2009 Edition 5.0 dated 07/01/2014
Figure A-2: Set iComm Server Properties
Set site specific IO Server Properties in the Advanced, Security and Defaults Tab. Once complete,
navigate to the General tab. Enter the connection information for the iComm Server, as illustrated
below in Figure A-2.
For example, enter the following:
• IO Server Name: enter a name for your IO Server.
• Type of IO Server: Select the type of IO Server
• Host Computer:- Enter the internal network DNS name or static IP address for the computer
running the IO Server; for example 'Computername'.
• External Address: Enter the valid external DNS name or static IP address for the computer running
the IO Server; for example 'DNSName.domain.com'.
Relaunch eServer. Check that it is using the updated Magellan project. Before finishing, ensure to
remove the Magellan Builder security dongle, leaving just the eServer security dongle to enable
operation of the eServer software.