Innotech eServer - Manual (Page 88)

eServer Setup and Site Installation Instructions
Page 88 © Mass Electronics Pty Ltd 2009 Edition 5.0 dated 07/01/2014
4-4.4 Test eServer Connectivity
Open Internet Explorer and in the Address Bar, enter your computer name or IP Address and the
HTML page name:
Example 1: http://[Computer Name]/index.htm
Example 2: http://[IP Address]/index.htm
If Security is set up on the project, you will be required to enter the authentication details, as
illustrated below in Figure 4-20.
When you exit the project, Internet Explorer will still be open. Add the address to your Favourites so
you don’t need to enter it manually each time.
Figure 4-20: Entering Connection Authentication Details
You will need to allow downloading of the Magellan ActiveX Control if prompted. Follow all
onscreen instructions to complete the test connection, and follow the steps outlined next in 4-5 -
Setup of eServer Client Computer .
There is a an online troubleshooting guide included for any connecting eServer Client computers. This will help to
resolve common connection problems such as Internet Explorer Security Settings which may block the installation of
the Magellan ActiveX Control.
NOTE