Innotech eServer - Manual (Page 36)

eServer Setup and Site Installation Instructions
Page 36 © Mass Electronics Pty Ltd 2009 Edition 5.0 dated 07/01/2014
3-1 Overview
This section provides an overview of the steps required to install and configure Windows Internet
Information Services (IIS) settings.
3-2 Installing Internet Information Services (IIS)
3-2.1 Overview
This section provides an overview of the steps required to install Windows Internet Information
Services (IIS) on supported operating systems. If the computer already has IIS Installed, you may skip
this section.
3-2.2 Installing IIS on Windows Server 2008 R2
These instructions detail the process for installing IIS on a Windows Server 2008 R2 computer. For a
computer with a fresh install of Windows Server 2008 R2, there will be an interface presented on the
screen to setup initial configuration options for your server computer.
It is recommended to have the server computer's initial configuration settings set by the site IT Manager.
NOTE
IIS enables your eServer Host computer the capability to interact securely with connecting eServer Client computers.
Once IIS has been installed, you will need to configure it to correctly to enable eServer to operate.
NOTE
IIS enables your eServer Host computer (the computer running the eServer software) the capability to interact
securely with connecting eServer Client computers. IIS is not enabled by default on a fresh install of Windows.
NOTE