Brother MFC-820CW - Manual (Page 130)

114
Checking the ink
volume
B
Although an ink volume icon appears on the
LCD, you can use the Ink key to see a large
graph showing the ink that is left in each
cartridge.
a
Press Ink.
b
Press a or b to choose Ink Volume.
Press OK.
The LCD shows the ink volume.
c
Press Stop/Exit.
Note
You can check the ink volume from your
computer. (See Chapter 1 or Chapter 8 in
the Software User's Guide on the
CD-ROM.)
Packing and shipping
the machine
B
When you transport the machine, use the
packing materials that came with your
machine. If you do not pack the machine
properly, you could void your warranty.
CAUTION
It is important to allow the machine to ‘park’
the print head after a print job. Listen
carefully to the machine before unplugging
it to make sure that all mechanical noise
has stopped. Not allowing the machine to
finish this parking process may lead to print
problems and possible damage to the print
head.
a
Lift the scanner cover from the right-
hand side of the machine until it locks
securely into the open position.
b
Take out all the ink cartridges and install
the yellow protective parts. (See
Replacing an ink cartridge on
page 117.)
When installing the yellow protective
parts, make sure they clip into place as
shown in the diagram.
CAUTION
If you are not able to find the yellow
protective parts, DO NOT remove the ink
cartridges before shipping. It is essential
that the machine be shipped with either the
yellow protective parts or the ink cartridges
in position. Shipping without them will
cause damage to your machine and may
void your warranty.
OK OK