Brother MFC-820CW - Manual (Page 70)

Chapter 7
54
c
Press a or b to choose
Set Quick-Dial.
Press OK.
d
Press a or b to choose
Setup Groups.
Press OK.
e
Press a or b to choose the Group you
want to delete.
Press OK.
f
Press a or b to choose Delete.
Press OK.
Then, confirm the Delete by pressing 1.
g
Press a or b to choose Complete.
Press OK.
h
Press Stop/Exit.
Deleting a number from a Group
7
a
Press Menu.
b
Press a or b to choose Fax.
Press OK.
c
Press a or b to choose
Set Quick-Dial.
Press OK.
d
Press a or b to choose
Setup Groups.
Press OK.
e
Press a or b to choose the Group you
want to change.
Press OK.
f
Press a or b to choose the number you
want to delete.
Press OK.
Then, confirm the Delete by pressing 1.
g
Press a or b to choose Complete.
Press OK.
h
Press Stop/Exit.
Access codes and credit card
numbers
7
Sometimes you may want to choose from
several long distance carriers when you make
a call. Rates may vary depending on the time
and destination. To take advantage of low
rates, you can store the access codes or long-
distance carriers and credit card numbers as
Speed-Dial numbers. You can store these
long dialing sequences by dividing them and
setting them up as separate Speed-Dial
numbers in any combination. You can even
include manual dialing using the dial pad. (See
Storing Speed-Dial numbers on page 50.)
For example, you have stored ‘555’ on
Speed-Dial: 03 and ‘7000’ on Speed-Dial: 02.
a
Press Search/Speed Dial.
b
Enter 03.
Note
If you stored 2 numbers in one Speed-Dial
location, you will be asked which number
you want to send to.
c
Press a or b to choose Speed-Dial.
Press OK.
d
Enter 02.
e
Press Black Start or Color Start.
You will dial ‘555-7000’.
To temporarily change a number, you can
substitute part of the number with manual
dialing using the dial pad. For example, to
change the number to 555-7001 you could
press Search/Speed Dial, 03 and then press
7001 using the dial pad.
Note
If you must wait for another dial tone or
signal at any point in the dialing sequence,
create a pause in the number by pressing
Redial/Pause. Each key press adds a
3.5-second delay.