Brother MFC-820CW - Manual (Page 85)

Making copies
69
11
Changing copy
settings
11
You can change the copy settings temporarily
for the next copy.
These settings are temporary, and the
machine returns to its default settings
60 seconds after copying, unless you have
set the Mode Timer to 30 seconds or less.
(See Setting the Mode Timer on page 21.)
If you have finished choosing settings, press
Black Start or Color Start.
If you want to choose more settings, press a
or b.
Note
You can save some of the settings that
you use most often by setting them as
default. These settings will stay until you
change them again. (See Setting your
changes as new default on page 73.)
Print quality
11
You can choose the copy quality. The factory
setting is Normal.
„ Fast
Fast copy speed and lowest amount of ink
used. Use this setting to save time
(documents to be proof read, large
documents or many copies).
„ Normal
Recommended setting for ordinary
printouts. Good copy quality with
adequate copy speed.
„ Best
Use this setting to copy precise images
such as photographs. The highest
resolution and slowest speed.
a
Press (Copy).
b
Load your document.
c
Enter the number of copies you want.
d
Press a or b to choose Quality.
Press OK.
e
Press a or b to choose Fast, Normal
or Best.
Press OK.
f
If you do not want to change additional
settings, press Black Start or
Color Start.
Enlarging or reducing the
copied image
11
You can choose an enlargement or reduction
ratio.
a
Press (Copy).
b
Load your document.
c
Enter the number of copies you want.
d
Press a or b to choose
Enlarge/Reduce.
Press OK.
e
Do one of the following:
„ Press a or b to choose the
enlargement or reduction ratio you
want. Press OK.
„ Press a or b to choose
Custom(25-400%)and then enter
an enlargement or reduction ratio
from 25% to 400%. Press OK.
(For example, press 5 3 to enter
53%.)
50%
69% A4iA5
78% LGLiLTR
83% LGLiA4
93% A4iLTR
97% LTRiA4
100%*
104% EXEiLTR